Digital-alert-systems DASDEC-II MANUAL Manual do Utilizador descarregar pdf (Página 110)

104  Digital Alert Systems: DASDEC User Manual

All EAS codes trigger

If enabled, all EAS codes will trigger the DVS644/SCTE18 client interface. In the next screen shot this option is

enabled. Set the checkbox to enable/disable EAS code filtered trigger control. If disabled, then the alert EAS

code is filtered for a specific match as a way to control whether or not DVS644/SCTE18 is triggered. If All EAS is

disabled, select EAS codes from the provided lists and add to the client EAS list. If the EAS codes of an active

forwarded/originated alert matches any of these EAS, the alert will be sent using the DVS-644/SCTE18 client.

With careful use of this feature, and with multiple clients, one DASDEC II can serve many different cable regions

at the same time.

DVS-644/SCTE18 Client Configuration Interface, bottom half of table

When you finish making changes, click to save the configuration.

4.10.5 Stream MPEG

If Streaming MPEG hardware/software is available on the One-NetSE, a tabbed page will display under Setup >

Net Alerts that allows configuration of up to two client targets. As in the other Net Alert pages, use the Alert

Forwarding and/or the Encoder Alert Stream toggles to enable/disable the use of streaming MPEG clients when

alerts are forwarded and/or originated.

1 2 ... 105 106 107 108 109 110 111 112 113 114 115 ... 170 171

Sem comentários

Digital-alert-systems DASDEC-II MANUAL Manual do Utilizador Página 110